STM32L552E-EV

STM32 Evaluation development board with STM32L552ZETxQ MCU

• Debug Interfaces
  JTAG/SW	20-pin JTAG (0.1 inch connector)
  JTAG/SW	20-pin Cortex debug + ETM Trace (0.05 inch connector)
  JTAG/SW	14-pin JTAG STDC14 interface (0.05 inch connector)
  JTAG/SW	10-pin TAG probe TC2050-IDC-NL
  ST-Link	Micro-USB

• Debug
  Integrated Debug Adaptor	1 x On-board ST-LINK/V2-1

• Other
  Crystal Oscillator	16 MHz 16 MHz Crystal Oscillator
  Other Feature	1 x Touch sensing button

• Power
  Power Supply	5 V - 0 V USB VBUS, ext. VIN, ext. 5V, ext +3.3V, 5V_USB_C
  Battery	1 x Coin-battery cell holder for power backup

• Connectors
  USB	1 x USB Type-C Sink device FS
  CAN	1 x CAN
  RS232	1 x RS232
  Other Connector Type	4 x I/O expansion connector
  Other Connector Type	1 x MEMS expansion connector
  Other Connector Type	1 x STMod+ expansion connector
  Other Connector Type	1 x Pmod expansion connector
  Other Connector Type	1 x Motor control connector
  Other Connector Type	1 x EXT_I2C connector

• Memory
  Flash	1 x 512-Mbit Octal-SPI Flash
  RAM	1 x 64-Mbit Octal HyperRAM
  RAM	1 x 16-Mbit SRAM
  Other Memory Type	1 x 128-Kbit I2C EEPROM
  SD/microSD/MMC Card Holder	1 x SDIO interface microSD card
  SD/microSD/MMC Card Holder	1 x Smartcard socket

• Audio
  Microphone	2 x Digital microphones
  Line In	1 x Audio CODEC with Stereo Line-In/Out and Speaker/Microphone
  Line Out	1 x Audio CODEC with Stereo Line-In/Out and Speaker/Microphone

• Sensors
  Ambient Light Sensor	1 x Light-dependent resistor

• Display
  GLCD	240 x 320 2.8 inch Color QVGA TFT LCD with resistive touchscreen
  LEDs	4 x LEDs: COM, Power, User LEDs

• Controls
  Joystick	1 x 5-position Joystick
  Potentiometer	1 x Analog Voltage Control for ADC Input (potentiometer)
  Push-buttons	4 Push-Buttons for Reset, Tamper and User