The TPM project is a simple demonstration program of the SDK TPM driver. It sets up the TPMhardware block to output PWM signals on two TPM channels. The PWM dutycycle on both channelsis manually updated. On boards that have an LED connected to the TPM pins, the user will seea change in LED brightness if user enter different values.

The TPM project is a simple demonstration program of the SDK TPM driver. It sets up the TPMhardware block to output a center-aligned PWM signal. The PWM dutycycle is manually updated.On boards that have an LED connected to the TPM pins, the user will see a change in LEDbrightness if user enter different values.

The TPM project is a simple demonstration program of the SDK TPM driver to use TPM as a timer.It sets up the TPM hardware block to trigger an interrupt every 1 millisecond.When the TPM interrupt is triggered a message a printed on the UART terminal.

The True Random Number Generator (TRNG) is a hardware accelerator module that generates a 512-bitentropy as needed by an entropy consuming module or by other post processing functions. The TRNGExample project is a demonstration program that uses the KSDK software to generate random numbersand prints them to the terminal.

The tsi_v4_low_power example shows how to use TSI_V4 driver in low power modes:In this example , we make use of the available electrodes on board to show driver usage.1. Firstly, we get the non-touch calibration results as baseline electrode counter;2. Then, we start the Hardware-Trigger scan using interrupt method to wakeup from low power modes through pad touch;3. Note: you can select which low power mode you want to enter into.

The tsi_v4_normal example shows how to use TSI_V4 driver in normal modes:In this example , we make use of the available electrodes on board to show driver usage.1. Firstly, we get the non-touch calibration results as baseline electrode counter;2. Then, we start the Software-Trigger scan using polling method and interrupt method;3. Then, we start the Hardware-Trigger scan using interrupt method.

The tstmr example shows the usage of TSTMR driver in application. The TSTMR module is a free running incrementing counter that starts running after system reset de-assertion and can be read at any time by the software for determining the software ticks.The TSTMR runs off the 1 MHz clock and resets on every system reset.In this example, it would output a time stamp information when the application is ready. And then, delay for 1 second with TSTMR_DelayUs() function. Before and after the delay, it would output the two time stamps information again.

The WDOG32 Example project is to demonstrate usage of the KSDK wdog32 driver.In this example, fast testing is first implemented to test the wdog32.After this, refreshing the watchdog in None-window mode and window mode is executed.Note wdog32 is disabled in SystemInit function which means wdog32 is disabledafter chip emerges from reset.