The TPM project is a demonstration program of the SDK TPM driver's input capture feature.The example sets up a TPM channel for dual-edge capture. Once the input signal is received,this example will print the capture value.

The TPM project is a demonstration program of the SDK TPM driver's output compare feature.It sets up one TPM channel to toggle the output when a match occurs with the channel value. The usershould probe the TPM output with a oscilloscope to see the signal toggling.

The TPM project is a simple demonstration program of the SDK TPM driver. It sets up the TPMhardware block to output PWM signals on two TPM channels. The PWM dutycycle on both channelsis manually updated. On boards that have an LED connected to the TPM pins, the user will seea change in LED brightness if user enter different values.

The TPM project is a simple demonstration program of the SDK TPM driver. It sets up the TPMhardware block to output a center-aligned PWM signal. The PWM dutycycle is manually updated.On boards that have an LED connected to the TPM pins, the user will see a change in LEDbrightness if user enter different values.

The TPM project is a simple demonstration program of the SDK TPM driver to use TPM as a timer.It sets up the TPM hardware block to trigger an interrupt every 1 millisecond.When the TPM interrupt is triggered a message a printed on the UART terminal.

The tsi_v4_low_power example shows how to use TSI_V4 driver in low power modes:In this example , we make use of the available electrodes on board to show driver usage.1. Firstly, we get the non-touch calibration results as baseline electrode counter;2. Then, we start the Hardware-Trigger scan using interrupt method to wakeup from low power modes through pad touch;3. Note: you can select which low power mode you want to enter into.

The tsi_v4_normal example shows how to use TSI_V4 driver in normal modes:In this example , we make use of the available electrodes on board to show driver usage.1. Firstly, we get the non-touch calibration results as baseline electrode counter;2. Then, we start the Software-Trigger scan using polling method and interrupt method;3. Then, we start the Hardware-Trigger scan using interrupt method.

The uart_edma ring buffer example shows how to use uart driver with EDMA:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.

The uart_edma example shows how to use uart driver with EDMA:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The uart_functioncal_interrupt example shows how to use uart driver functionalAPI to receive data with interrupt method:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.