The flexcan_loopback example shows how to use the loopback test mode to debug your CAN Bus design:To demonstrates this example, only one board is needed. The example will config one FlexCAN MessageBuffer to Rx...See more details in readme document.

The flexcan_loopback example shows how to use the loopback test mode to debug your CAN Bus design:To demonstrates this example, only one board is needed. The example will config one FlexCAN MessageBuffer to Rx...See more details in readme document.

The flexcan_ping_pong_buffer_transfer example shows how to use the FlexCAN queue feature to create 2 simulate FIFOs that can receive CAN frames:In this example, 2 boards are connected through CAN bus. Endpoint...See more details in readme document.

The flexcan_ping_pong_buffer_transfer example shows how to use the FlexCAN queue feature to create 2 simulate FIFOs that can receive CAN frames:In this example, 2 boards are connected through CAN bus. Endpoint...See more details in readme document.

The flexio3_lpi2c_interrupt example shows how to use flexio i2c master driver in interrupt way:In this example, a flexio simulated i2c master connect to a LPI2C slave

The flexio3_lpi2c_interrupt example shows how to use flexio i2c master driver in interrupt way:In this example, a flexio simulated i2c master connect to a LPI2C slave

The flexio3_i2s_interrupt example shows how to use flexio_i2s driver with interrupt:In this example, flexio acts as I2S module to record data from line-in line and playbacks the recorded data at the same time using interrupt.

The flexio3_i2s_interrupt example shows how to use flexio_i2s driver with interrupt:In this example, flexio acts as I2S module to record data from line-in line and playbacks the recorded data at the same time using interrupt.

This demo describes how to use SDK drivers to implement the PWM feature by FLEXIO IP module. It outputs the PWM singal with fixed frequency defined by "DEMO_FLEXIO_FREQUENCY" in source code and dynamic duty from 99 to 1 to one of the FLEXIO pin.

This demo describes how to use SDK drivers to implement the PWM feature by FLEXIO IP module. It outputs the PWM singal with fixed frequency defined by "DEMO_FLEXIO_FREQUENCY" in source code and dynamic duty from 99 to 1 to one of the FLEXIO pin.