The EDMA memory to memory example is a simple demonstration program that uses the SDK software.It excuates one shot transfer from source buffer to destination buffer using the SDK EDMA drivers.The purpose of this example is to show how to use the EDMA and to provide a simple example fordebugging and further development.

The EDMA memory to memory example is a simple demonstration program that uses the SDK software.It excuates one shot transfer from source buffer to destination buffer using the SDK EDMA drivers.The purpose of this example is to show how to use the EDMA and to provide a simple example fordebugging and further development.

The EEPROM flash demo application demonstrates the use of the LPI2C IP and driver to read and write data from anexternal EEPROM device.

The EWM Example project is to demonstrate usage of the KSDK EWM driver.In the example, EWM counter is continuously refreshed until button is pressed.Once the button is pressed, EWM counter will expire and interrupt will be generated.After the first pressing, another interrupt can be triggered by pressing button again.

The flexcan_interrupt example shows how to use FlexCAN driver in none-blocking interrupt way:In this example, 2 boards are connected through CAN bus. Endpoint A(board A) send a CAN Message toEndpoint B(board B) when user press space key in terminal. Endpoint B receive the message, printthe message content to terminal and echo back the message. Endpoint A will increase the receivedmessage and waiting for the next transmission of the user initiated.

The flexcan_loopback_functional example shows how to use the loopback test mode to debug your CAN Bus design:To demonstrates this example, only one board is needed. The example will config one FlexCAN MessageBuffer to Rx Message Buffer and the other FlexCAN Message Buffer to Tx Message Buffer with same ID.After that, the example will send a CAN Message from the Tx Message Buffer to the Rx Message Bufferthrouth internal loopback interconnect and print out the Message payload to terminal.

The flexcan_loopback_edma example shows how to use the EDMA version transactional driver to receiveCAN Message from Rx FIFO:To demonstrates this example, only one board is needed. The example will config one FlexCAN MessageBuffer to Tx Message Buffer and also setup Rx FIFO. After that, the example will send 4 CAN Messagesfrom Tx Message Buffer to Rx FIFO through internal loopback interconnect and read them out usingEDMA version FlexCAN transactional driver. The Sent and received message will be print out to terminalat last.

The flexcan_loopback example shows how to use the loopback test mode to debug your CAN Bus design:To demonstrates this example, only one board is needed. The example will config one FlexCAN MessageBuffer to Rx Message Buffer and the other FlexCAN Message Buffer to Tx Message Buffer with same ID.After that, the example will send a CAN Message from the Tx Message Buffer to the Rx Message Bufferthrough internal loopback interconnect and print out the Message payload to terminal.

The flexio_lpi2c_interrupt example shows how to use flexio i2c master driver in interrupt way:In this example, a flexio simulated i2c master connect to a LPI2C slave

The flexio_spi_master_edma_dspi_slave example shows how to use flexio spi master driver in edma way:In this example, a flexio simulated master connect to a dspi slave .