The FLASIAP project is a simple demonstration program of the SDK FLASIAP driver. It erases and programs a portion of on-chip flash memory. A message a printed on the UART terminal as various operations on flash memory are performed.

The fmc example project is a demonstration program that uses the KSDK software to generate flash signaturefor a specified flash address range and prints them to the terminal. This example also implements the softwaresignature algorithm, compares the hardware signature result and software signature result. This is to verify flash contents as suggested by user manual.

This example shows how to use SDK drivers to use the Frequency Measure feature of SYSCON module on LPC devices.It shows how to measure a target frequency using a (faster) reference frequency. The example uses the internal main clock as the reference frequency to measure the frequencies of the RTC, watchdog oscillator, and internal RC oscillator.

This example shows how to use SDK drivers to use the Group GPIO input interrupt peripheral.

The GPIO Example project is a demonstration program that uses the KSDK software to manipulate the general-purposeoutputs. The example use LEDs and buttons to demonstrates GPIO API for port and pin manipulation (init, set,clear, and toggle).

The Hello World demo application provides a sanity check for the new SDK build environments and board bring up. The HelloWorld demo prints the "Hello World" string to the terminal using the SDK UART drivers. The purpose of this demo is toshow how to use the UART, and to provide a simple project for debugging and further development.

The i2c_dma_b2b_transfer_master example shows how to use i2c driver as master to do board to board transfer with DMA:In this example, one i2c instance as master and another i2c instance on the other board as slave. Master sends a piece of data to slave, and receive a piece of data from slave. This example checks if the data received from slave is correct.

The i2c_dma_b2b_transfer_slave example shows how to use i2c driver as slave to do board to board transfer with a DMA master:In this example, one i2c instance as slave and another i2c instance on the other board as master. Master sends a piece of data to slave, and receive a piece of data from slave. This example checks if the data received from slave is correct.

The i2c_interrupt_b2b_transfer_master example shows how to use i2c driver as master to do board to board transfer with interrupt:In this example, one i2c instance as master and another i2c instance on the other board as slave. Master sends a piece of data to slave, and receive a piece of data from slave. This example checks if the data received from slave is correct.

The i2c_interrupt_b2b_transfer_slave example shows how to use i2c driver as slave to do board to board transfer with interrupt:In this example, one i2c instance as slave and another i2c instance on the other board as master. Master sends a piece of data to slave, and receive a piece of data from slave. This example checks if the data received from slave is correct.