This example shows how to use DMA to transfer data from DMIC to memory.

Demonstrates the DMIC working with I2S. Audio is converted to samples in the DMIC module.Then, the data is placed memory buffer. Last, it is send data to the I2S buffer and send to the CODEC, then the audio data will be output to Lineout of CODEC.~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

The EEPROM Example project is a demonstration program that uses the KSDK software to program eeprom memoryand verify the program.

The emc_sdram example shows how to access the SDRAM.In this example, user shall initialize the EMC (external memory controller), initialize theEMC dynamic memory controller before access the external SDRAM.If the sdram example fails, please make sure to check the following points:1. Please take refer to the board.readme to check the jumper settings on your board.2. Please take refer to the EMC chapter in API RM to do the delay calibration to found the best delay for your board, then update the delay to the EMC clock delay control registers in the system configure module registers.

The enet_rxtx_ptp1588_transfer example shows the way to use ENET driver to receive and transmit frame in the 1588 feature required cases.1. This example shows how to initialize the ENET.2. How to get the time stamp of the PTP 1588 timer.3. How to use Get the ENET transmit and receive frame time stamp.The example transmits 20 number PTP event frame, shows the timestamp of the transmitted frame.The length, source MAC address and destination MAC address of the received frame will be print. The time stamp of the received timestamp will be print when the PTP message frame is received(the outside loopback cable can be used to see the right rx time-stamping log since we send the ptp message).

The enet_rxtx_rxinterrupt example shows the simplest way to use ENET functional tx/rx API for simple frame receive and transmit.1. This example shows how to initialize the ENET.2. How to use ENET to receive frame in interrupt irq handler and to transmit frame.The example transmits 20 number broadcast frame, print the number of recieved frames. To avoidthe receive number overflow, the transmit/receive loop with automatically break when 20 numberare received.

The enet_rxtx_rxinterrupt example shows the simplest way to use ENET functional tx/rx API for simple frame receive and transmit.1. This example shows how to initialize the ENET.2. How to use ENET to receive frame in polling and to transmit frame.The example transmits 20 number broadcast frame, print the number and the mac address of the recieved frames.

The enet_rxtx_rxinterrupt example shows the simplest way to use ENET transactional tx/rx API for simple frame receive and transmit.1. This example shows how to initialize the ENET.2. How to use ENET to receive frame in interrupt irq handler and to transmit frame.The example transmits 20 number broadcast frame, print the number of recieved frames. To avoidthe receive number overflow, the transmit/receive loop with automatically break when 20 numberare received.

The nor flash demo application demonstrates the use of nor flash component to erase, program, and read an external flash device.

The FLASIAP project is a simple demonstration program of the SDK FLASIAP driver. It erases and programs a portion of on-chip flash memory. A message a printed on the UART terminal as various operations on flash memory are performed.