The lpuart_interrupt Example project is to demonstrate usage of the KSDK lpuart driver.In the example, you can send characters to the console back and they will be printed out onto console in a group of 8 characters.

The lpuart_polling Example project is to demonstrate usage of the KSDK lpuart driver.In the example, you can send characters to the console back and they will be printed out onto console instantly.

The pdb_adc12_trigger example shows how to use the PDB to generate a ADC trigger.Based on the basic counter, to use the ADC trigger, just to enable the ADC trigger's "milestone" and set the user-defined value for it.After the PDB counter is triggered to start, when the counter pass the "milestone", the ADC's Pre-Trigger would be generated and sentto the ADC12 module.In this example, the ADC12 is configured with hardware trigger and conversion complete interrupt enabled.Once it gets the trigger from the PDB, the conversion goes, then the ISR would be executed.

The pflash example shows how to use flash driver to operate program flash:

The SCG example shows how to use SCG driver: 1. How to setup the SCG clock source. 2. How to use SCG clock while power mode switch. 3. How to use SCG APIs to get clock frequency.This example prints the clock frequency through the terminal using the SDK driver.

The SYSMPU example defines protected/unprotected memory region for the core access.First, the SYSMPU will capture the hardware information and show it on theterminal. Then, a memory region is configured as the non-writable region. Thebus fault interrupt is enabled to report the memory protection interrupt eventfor this non-writable region. If an operation writes to this region, the busfault interrupt happens. Then the bus fault interrupt handler provides aprevention alert by outputting a message on terminal, then the write rightswill be given to this region for core access. After the write access enabled,the writing to the region becomes successful. When the bus fault happen, thedetails of the error information will be captured and printed on the terminal.This example provides the terminal input control to give the example show for several regions access test. Just press any key to the terminal when theterminal show "Press any key to continue".

The WDOG32 Example project is to demonstrate usage of the KSDK wdog32 driver.In this example, fast testing is first implemented to test the wdog32.After this, refreshing the watchdog in None-window mode and window mode is executed.Note wdog32 is disabled in SystemInit function which means wdog32 is disabledafter chip emerges from reset.