The lpuart_polling Example project is to demonstrate usage of the KSDK lpuart driver.In the example, you can send characters to the console back and they will be printed out onto console instantly.

The lpuart_polling_seven_bits Example project is to demonstrate usage of the KSDK lpuart driver with seven data bits feature enabled.In the example, you can send characters to the console back and they will be...See more details in readme document.

This example demonstrates the control of the PMSM.

The OPAMP basic example demonstrates how to use the OPAMP driver. In this example, the OPAMP works in the internal gain mode, connect the positive terminal of the OPAMP to the external input source. The OPAMP output...See more details in readme document.

The OPAMP DAC LPADC example demonstrates how to use the OPAMP driver. In this example, the OUTSW, BUFFEN, ADCSW1, and ADCSW2 are enabled, and the user can use the ADC to measure the OPAMPx_INT voltage and the...See more details in readme document.

The OSTIMER project is a simple demonstration program of the SDK OSTIMER driver. It sets the OSTIMER as the wakeup source from deep-sleep mode. After wakeup from deep-sleep mode, OS timer will set match value to...See more details in readme document.

Low level power_mode_switch demo.

The PWM project is a simple demonstration program of the SDK PWM driver.The pulse width modulator (PWM) module contains PWM submodules, each of which is set up to control a single half-bridge power stage.Fault...See more details in readme document.

The runbootloader project is a simple demonstration which run into the bootloader with the user parameter. The demo forces the device run into the ISP mode with the specific peripheral.

The utick project is a simple demonstration program of the SDK utick driver. It sets up the utick hardware block to trigger a periodic interrupt after every 1 second. When the utick interrupt is triggered a message is printed on the UART terminal.