The EDMA3 wrap transfer example is a simple demonstration program that uses the SDK software.The purpose of this example is to show how to use the EDMA3 and to provide a simple example for debugging and further development.

The EQDC project shows how to sample the shaft position based on quadrature signal (PHASEA and PHASEB).

The EQDC project shows how to sample the shaft position based on quadrature signal (PHASEA and PHASEB).

The ERM Single Error project is a simple demonstration program of the SDK ERM driver. It shows how to show error events using the ERM driver.

The FLASIAP project is a simple demonstration program of the SDK FLASIAP driver. It erases and programs a portion of on-chip flash memory. A message a printed on the UART terminal as various operations on flash memory are performed.

The flexcan_interrupt example shows how to use FlexCAN driver in none-blocking interrupt way:In this example, 2 boards are connected through CAN bus. Endpoint A(board A) send a CAN Message toEndpoint B(board B) when...See more details in readme document.

The flexcan_loopback_functional example shows how to use the loopback test mode to debug your CAN Bus design:To demonstrates this example, only one board is needed. The example will config one FlexCAN MessageBuffer...See more details in readme document.

The flexcan_loopback example shows how to use the loopback test mode to debug your CAN Bus design:To demonstrates this example, only one board is needed. The example will config one FlexCAN MessageBuffer to Rx...See more details in readme document.

The flexcan_ping_pong_buffer_transfer example shows how to use the FlexCAN queue feature to create 2 simulate FIFOs that can receive CAN frames:In this example, 2 boards are connected through CAN bus. Endpoint...See more details in readme document.

The flexcan_pretended_networking_wakeup example shows how to wake up FLEXCAN module from Pretended Networking mode:In this example, 2 boards are connected through CAN bus. Endpoint A(board A) send a CAN Message to...See more details in readme document.