The LED Blinky demo application provides a sanity check for the new SDK build environments and board bring up. The LED Blinky demo uses the systick interrupt to realize the function of timing delay. The example takes turns to shine the LED. The purpose of this demo is to provide a simple project for debugging and further development.

The log demo is used to demonstrate how to use log component. The main function of the demo is to prompt the LOG level string according to the user input log level command.

The LPTMR project is a simple demonstration program of the SDK LPTMR driver. It sets up the LPTMRhardware block to trigger a periodic interrupt after every 1 second. When the LPTMR interrupt is triggereda message a printed on the UART terminal and an LED is toggled on the board.

The lpuart_9bit_interrupt_transfer example shows how to use lpuart driver in 9-bit mode in multi-slave system. Master can send data to slave with certain address specifically, and slave can only receive data when it is addressed. In this example, one lpuart instance is used with address configured. Its TX and RX pins are connected together. First it sends a piece of data out, then addresses itself, after that sends the other piece of data. Only data sent after the address can be received by itself.

The lpuart_edma Ring Buffer Example project is to demonstrate usage of the KSDK lpuart driver.

The lpuart_edma Example project is to demonstrate usage of the KSDK lpuart driver.In the example, you can send characters to the console back and they will be printed out onto console in a group of 8 characters.

The lpuart_functioncal_interrupt example shows how to use lpuart driver functionalAPI to receive data with interrupt method:In this example, one lpuart instance connect to PC, the board willsend back all characters that PC send to the board.

The lpuart_interrupt_ring_buffer Example project is to demonstrate usage of the KSDK lpuart driver.In the example, you can send characters to the console back and they will be printed out onto console in a group of 8 characters.

The lpuart_interrupt Example project is to demonstrate usage of the KSDK lpuart driver.In the example, you can send characters to the console back and they will be printed out onto console in a group of 8 characters.

The lpuart_polling Example project is to demonstrate usage of the KSDK lpuart driver.In the example, you can send characters to the console back and they will be printed out onto console instantly.