The TPM project is a demonstration program of the SDK TPM driver's input capture feature.The example sets up a TPM channel for dual-edge capture. Once the input signal is received,this example will print the capture value.

The TPM project is a demonstration program of the SDK TPM driver's output compare feature.It sets up one TPM channel to toggle the output when a match occurs with the channel value. The usershould probe the TPM output with a oscilloscope to see the signal toggling.

The TPM project is a simple demonstration program of the SDK TPM driver. It sets up the TPMhardware block to output PWM signals on two TPM channels. The PWM dutycycle on both channelsis manually updated. On boards that have an LED connected to the TPM pins, the user will seea change in LED brightness if user enter different values.

The TPM project is a simple demonstration program of the SDK TPM driver. It sets up the TPMhardware block to output a center-aligned PWM signal. The PWM dutycycle is manually updated.On boards that have an LED connected to the TPM pins, the user will see a change in LEDbrightness if user enter different values.

The TPM project is a simple demonstration program of the SDK TPM driver to use TPM as a timer.It sets up the TPM hardware block to trigger an interrupt every 1 millisecond.When the TPM interrupt is triggered a message a printed on the UART terminal.

The uart_9bit_interrupt_transfer example shows how to use uart driver in 9-bit mode in multi-slave system. Master can send data to slave with certain address specifically, and slave can only receive data when it is addressed. In this example, one uart instance is used with address configured. Its TX and RX pins are connected together. First it sends a piece of data out, then addresses itself, after that sends the other piece of data. Only data sent after the address can be received by itself.

The uart_edma ring buffer example shows how to use uart driver with EDMA:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.

The uart_edma example shows how to use uart driver with EDMA:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The uart_functioncal_interrupt example shows how to use uart driver functionalAPI to receive data with interrupt method:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.

The uart_interrupt_ring_buffer example shows how to use uart driver in interrupt way withRX ring buffer enabled:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.