The FTM project is a demonstration program of the SDK FTM driver's input capture feature.The example sets up a FTM channel for dual-edge capture. Once the input signal is received,this example will print the capture value.

The FTM project is a demonstration program of the SDK FTM driver's output compare feature.It sets up one FTM channel to toggle the output when a match occurs with the channel value. The usershould probe the FTM output with a oscilloscope to see the signal toggling.

The FTM / PDB demo application demonstrates how to use the FTM external trigger to start the ADC conversion using thePDB. FTM0 is configured as a complementary combined mode, and each channel output frequency is 16 KHz. The complementarychannel dead time is 1 µs. The PDB pre-trigger works in back-to-back mode. The ADC0 and ADC1 work in single-end mode.The ADC0 uses channel 1 and channel 5, and ADC1 uses channel 1 and channel 7.

The FTM pwm two channel Example project is a demonstration program that uses the KSDK software to generate a square pulse PWM on 2 channel to control the LED brightness.- FTM generates a PWM with the increasing and decreasing duty cycle.- LED brightness is increasing and then dimming. This is a continuous process.

This demo describes the usage of Quad Decoder feature in FTM module, which can be used to count the position of decoder.An external decoder is used to generate the PHA and PHB's signal. These two signals are feed to the FTM pins with Quad Decoder feature (FTMx_QD_PHA and FTMx_QD_PHB). Then, the counter value and direction would be displayed in terminal window predically.

This demo describes the usage of Quad Decoder feature in FTM module, which can be used to count the position of decoder.An external decoder is used to generate the PHA and PHB's signal. These two signals are feed to the FTM pins with Quad Decoder feature (FTMx_QD_PHA and FTMx_QD_PHB). Then, the counter value and direction would be displayed in terminal window predically. You can open the mex file with MCUXpresso Config Tool to do further configuration of pin, clock and peripheral.

The FTM project is a simple demonstration program of the SDK FTM driver. It sets up the FTMhardware block to output a center-aligned PWM signal. The PWM dutycycle is periodically updated.On boards that have an LED connected to the FTM pins, the user will see a change in LED brightness.

The FTM project is a simple demonstration program of the SDK FTM driver to use FTM as a timer.It sets up the FTM hardware block to trigger an interrupt every 1 millisecond.When the FTM interrupt is triggered a message a printed on the UART terminal.

The GPIO Example project is a demonstration program that uses the KSDK software to manipulate the general-purposeoutputs.The example is supported by the set, clear, and toggle write-only registers for each port output data register. The example uses the software button to control/toggle the LED.

The GPIO Example project is a demonstration program that uses the KSDK software to manipulate the general-purposeoutputs.The example is supported by the set, clear, and toggle write-only registers for each port output data register. The example take turns to shine the LED.