The RTC demo application demonstrates the important features of the RTC Module by using the RTC Peripheral Driver.The RTC demo supports the following features:- Calendar + Get the current date time with Year, Month, Day, Hour, Minute, and Second. + Set the current date time with Year, Month, Day, Hour, Minute, and Second.- Alarm + Set the alarm based on the current time. + Application prints a notification when the alarm expires.- Seconds interrupt + Use second interrupt function to display a digital time blink every second.

The Shell Demo application demonstrates to control Leds by commands.

SNMP Agent demo (CycloneTCP and CMSIS-RTOS2)

The SYSMPU example defines protected/unprotected memory region for the core access.First, the SYSMPU will capture the hardware information and show it on theterminal. Then, a memory region is configured as the non-writable region. Thebus fault interrupt is enabled to report the memory protection interrupt eventfor this non-writable region. If an operation writes to this region, the busfault interrupt happens. Then the bus fault interrupt handler provides aprevention alert by outputting a message on terminal, then the write rightswill be given to this region for core access. After the write access enabled,the writing to the region becomes successful. When the bus fault happen, thedetails of the error information will be captured and printed on the terminal.This example provides the terminal input control to give the example show for several regions access test. Just press any key to the terminal when theterminal show "Press any key to continue".

TCP client demo (CycloneTCP and CMSIS-RTOS2)

The uart_9bit_interrupt_transfer example shows how to use uart driver in 9-bit mode in multi-slave system. Master can send data to slave with certain address specifically, and slave can only receive data when it is addressed. In this example, one uart instance is used with address configured. Its TX and RX pins are connected together. First it sends a piece of data out, then addresses itself, after that sends the other piece of data. Only data sent after the address can be received by itself.

The uart_edma ring buffer example shows how to use uart driver with EDMA:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.

The uart_edma example shows how to use uart driver with EDMA:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The uart_hardware_flow_control example project is to demonstrate usage of the hardware flow control function.This example will send data to itself(loopback), and hardware flow control will be enabled in the example.The CTS(clear-to-send) pin is for transmiter to check if receiver is ready, if the CTS pin is assert, transmiter startto send data. The RTS(request-to-send) is a pin for receiver to inform the transmiter if receiver is ready to receivedata. So, please connect RTS to CTS pin directly.

The uart_functioncal_interrupt example shows how to use uart driver functionalAPI to receive data with interrupt method:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.